Orca Bag Charm

바느질용 송곳이나 펀처를 사용해 종이 위에 바로 바느질 구멍을 뚫습니다.

O-링 스트랩에 리벳을 수용할 구멍을 뚫기 위해 3mm 홀 펀처를 사용하십시오(주석이 있는 요소) 에프 on the pattern) and a 4mm hole punch for the eyes on elements 비.

가위나 X-Acto 칼을 사용하여 프로젝트의 모든 부분을 잘라냅니다.

The colors I used for this project couldn’t be simpler: black and white Angelus paints!

Create a loop at the end of the O-ring strap (이자형) with a rivet, using your rivet setter to set it up.

Set the plastic eyes in place in their sockets.

Apply a generous amount of glue to the backside in order to secure them in place and wait for it to dry completely.

Start stitching the white motif next to the eye (ㅏ ~에 비) 새들 스티치를 사용합니다.

Next stitch the top part of the body to the belly (비 ~ 위에 씨) using a black thread and a saddle stitch.

Don’t forget to add the fin (디) in between.

To join both halves of the orca, start by joining the belly (C1 그리고 C2) using a white thread and a cross-stitch.

You can use a saddle stitch if you wish (it’s a bit easier) but the cross-stitch makes the orca look more 3 dimensional.

Switch to a black thread to continue stitching both halves of the orca.

Once you reach the hole at the tip of the body, add the tail (에프).

This is the procedure I followed:

• 1 cross stitch between the left and right holes, ending in the same two opposite holes instead of progressing to the next two holes.
• left thread goes through hole in the tail, crosses to enter right hole and comes back through left hole.
• right thread goes through hole in the tail, crosses to enter left hole and comes back through the right hole.
• 1 cross stitch between the left and right holes now above the tail, progressing to the next two holes.

Add some stuffing as you progressively close the orca’s body.

Add the O-ring strap (이자형) between the two halves of the body (지하 1층 그리고 지하 2층).

That’s it! Congratulations on making a beautiful orca bag charm!

Complete your bag charm by adding the O-ring carabiner to the strap (이자형).